Effects of bed materials on the performance of an anaerobic sequencing batch biofilm reactor treating domestic sewage

The objective of this study was to determine the best performance of an anaerobic sequencing batch biofilm reactor (AnSBBR) based on the use of four different bed materials as support for biomass immobilization. The bed materials utilized were polyurethane foam (PU), vegetal carbon (VC), synthetic pumice (SP), and recycled low-density polyethylene (PE). The AnSBBR, with a total volume of 7.2L, was operated in 8-h batch cycles over 10 months, and fed with domestic sewage with an average influent chemical oxygen demand (COD) of 358+/-110mg/L. The average effluent COD values were 121+/-31, 208+/-54, 233+/-52, and 227+/-51mg/L, for PU, VC, SP, and PE, respectively. A modified first-order kinetic model was adjusted to temporal profiles of COD during a batch cycle, and the apparent kinetic constants were 0.52+/-0.05, 0.37+/-0.05, 0.80+/-0.04, and 0.30+/-0.02h(-1) for PU, VC, SP, and PE, respectively. Specific substrate utilization rates of 1.08, 0.11, and 0.86mg COD/mgVS day were obtained for PU, VC, and PE, respectively. Although SP yielded the highest kinetic coefficient, PU was considered the best support, since SP presented loss of chemical constituents during the reactor's operational phase. In addition, findings on the microbial community were associated with the reactor's performance data. Although PE did not show a satisfactory performance, an interesting microbial diversity was found on its surface. Based on the morphology and denaturing gradient gel electrophoresis (DGGE) results, PE showed the best capacity for promoting the attachment of methanogenic organisms, and is therefore a material that merits further analysis. PU was considered the most suitable material showing the best performance in terms of efficiency of solids and COD removal.     

污泥加热预处理对中温厌氧消化的影响

对污泥加热预处理给中温厌氧混合消化和污泥单独消化带来的影响进行了研究.研究结果表明,污泥加热预处理有利于提高混合消化对 COD 的去除率,尤其是 SCOD 的去除率由 77%增长到 93%,但不利于 TS 和 VS 的去除;而对污泥单独消化,预处理则不利于有机物的去除.采用加热预处理后的污泥进样,混合消化和污泥单独消化的甲烷产气量均有所提高.     

焚烧飞灰重金属含量及浸出长期变化规律研究

通过对24个飞灰样品的重金属全量消解和高精度X射线荧光光谱法（HDXRF）快速检测结果进行线性回归分析,发现HDXRF法可较准确测定飞灰中Cu、Pb、Zn、Ni和Cd含量（线性回归决定系数R²³0.90）.采用HDXRF法对某焚烧厂飞灰重金属含量6个月快速检测及浸出毒性测定数据统计分析发现：飞灰重金属月均含量较稳定（变异系数CV<0.14）但日均含量波动较大（CV>2.54）;飞灰中Pb、Cu和Zn含量呈正相关（相关系数r>0.78）;金属浸出浓度受浸出液终点pH值影响显著,超标频率依次为Pb（68.9%）、Cd（66.1%）、Ni（24.0%）、Cu（14.2%）和Zn（1.6%）.短期飞灰金属含量和浸出毒性数据受焚烧工况,烟气处理工况和垃圾组分等多种因素共同影响,不具有代表性.为评估垃圾分类源头削减重金属效果,建议采用快速检测方法对焚烧飞灰重金属含量进行长期监测.     

关于中小城市生活垃圾的处理与回收利用的探讨

对城市生活垃圾的分类回收、处理进行了探讨，对完善城市基础设施建设，改善投资环境将起到重要作用。     

垃圾填埋场渗出液中有害成分的研究

研究垃圾填埋场渗出液中的有害成分。渗出液样品用适当的方法处理后 ,用气相色谱 -质谱联用方法和原子发射光谱法进行定性分析。然后用原子吸收分光光度法和反相高效液相色谱法定量测定样品中微量的 Cu、Zn、Pb、Cr、Cd、Hg、苯酚、对甲苯酚、萘、蒽     

厌氧填埋垃圾降解阶段指标体系的建立

以厌氧填埋场中垃圾的降解过程为依托点,从渗滤液的水质特征和填埋气的组成两个方面筛选出判断指标,最后建立判断填埋垃圾降解阶段的指标体系.结果表明,ρ(BOD5)/ρ(COD)可以反映出渗滤液的可生化性,从而间接反映出填埋垃圾所处的降解阶段,是判断填埋垃圾降解阶段的重要定量指标.     

哈尔滨市生活垃圾处理产业化探讨

随着我国经济发展和人民生活水平的不断提高,城市垃圾产生量也不断增加,垃圾处理越来越受到人们的重视,垃圾处理产业也逐渐兴起.由于地区差异,工业发达程度和生活水平不同,不同的国家和地区有着不同的垃圾组成,相应的也采取不同的垃圾处理方法.哈尔滨市的生活垃圾处理现状具有一定的典型性,文章结合哈尔滨市实际情况,主要论述哈尔滨市生活垃圾的产量、特性及目前的处理状况,分析哈尔滨市生活垃圾问题的实质,对垃圾处理产业化存在的问题及其对策进行探讨,以期更好地促进生活垃圾处理步入产业化的发展轨道.     

生活垃圾生物处理的研究与展望

综述了国内外生活垃圾生物处理的研究进展和目前生活垃圾微生物研究水平，以及生活垃圾处理发展趋势与新动向，在此基础上提出了生活垃圾处理的建议和展望。     

凤眼莲在净化废水方面的应用

本文初步探讨了凤眼莲在净化废水方面的应用效果。结果表明，凤眼莲对生活废水具有较强的适应能力和净化效果。同时，其经特殊的处理后钻井废水中也能较正常生长、繁殖，并起一定的净化作用。文中就废水pH对凤眼莲的影响作了初步实验探讨，对凤眼莲净化废水机理也作了简述。     

新型生活污水处理装置研究

介绍了新型生活污水处理装置的工艺 ,影响装置处理效果的主要因素。